Lishida White Rice Vinegar is mainly used for pickling,making salads,sweet and sour dishes and sushi foods.Brewed from rice and other high quality ingredients,many families cook sweet & sour spare ribs,fish with this great vinegar.Welcome to share your recipes for white rice vinegar to us and people loving cuisines! White Rice Vinegar White Rice Wine,Chinese White Vinegar,Rice Vinegar White Vinegar,White Rice Wine Vinegar KAIPING CITY LISHIDA FLAVOURING&FOOD CO.,LTD , https://www.lishidafood.com
Treatment of Several Oil Spills in Tractors
First, the switch oil leakage switch includes drain valve, fuel tank switch and petrol switch. Oil leakage causes and countermeasures: If the ball valve is worn or rusted, the rust between the ball valve and the seat hole should be eliminated and a suitable steel ball should be used instead. If the packing and fastening threads are damaged, the fasteners should be repaired or replaced and the packing replaced. If the cone joint surface is not tight, fine sand and oil can be used for grinding. Second, the pipe joint leakage pipe joints include two major categories of cone joints and hollow bolt joints. (1) Cone-face press fitting joints include pipe fittings at both ends of the pressure gauge, one end of the gasoline pipe, two ends of the high-pressure fuel pipe, and the coarse fuel filter to the end of the oil pump. Oil leakage causes and countermeasures: If it is deformed or cracked due to wear of high-pressure tubing fittings, it can be sawn off and replaced with a good one. If the low-pressure tubing connector is damaged, the bell mouth can be sawed out and the new bell can be rebuilt. If the thread is damaged, it should be trimmed or replaced with a new one. (2) Hollow bolt fittings, including coarse fuel, fine filters, and low-pressure fuel injection fittings for injection pumps. Oil leakage reasons and countermeasures: If the gasket is damaged or the assembly is uneven, plastic gaskets can be used instead, or even iron can be used for leveling. It can also be used to grind flat paper. Severe milling can be done on the milling machine. If there is a pull mark on the assembly plane of the fitting, or use fine sandpaper or Whetstone to grind the joint assembly plane and gasket. If there are impurities on the mating surface, the body should be cleaned during assembly and the connector fixing bolts should be tightened evenly. Third, the rotary shaft oil leakage rotary shaft including the starter's shift lever shaft and clutch handle shaft and the engine's pressure relief shaft. Oil leakage causes and countermeasures: If the shaft and hole wear each other, the gearbox shaft and clutch handle shaft of the starter can be turned out of the seal ring groove on the lathe, and the corresponding size of the seal apron can be installed. If the aging of the apron due to decompression shaft fails, replace the new apron. Fourth, plug plugging plug oil plug plug plug plug, plug and plug process. Oil leakage Cause Countermeasure: If the oil plug screw is damaged or unqualified, it should be replaced with new one. If the screw screw is damaged, the screw hole size can be increased and the new oil plug can be fitted. If the taper plug is worn out, tapping can be changed to flat plugging after tapping, then the pad can be used again. V. Plane entanglement and oil leakage Plane seams include two planes sealed with paper pads, asbestos pads and cork. Oil leakage causes and countermeasures If the contact surface is uneven or there are grooves or burrs on the contact surface, it can be ground with a file, sandpaper, or oil stone. Large parts can be machined with the machine tool. If the gasket is not properly assembled or stained with impurities or gaskets, use qualified products when assembling gaskets. Clean and place them properly. If the bolts are loose, tighten each bolt.