How to operate the sealing machine correctly The first step, wearing the film to get the film to confirm the film winding direction, find the counterclockwise direction, and put it on the film rod to fix. (Please turn off the power when wearing the film.) Pay attention to whether the front and rear fixing plates of the film are tightly combined with the film. If it cannot be tightly combined, use a utility knife to cut the inside of the film tube into a bevel. After putting on the film, use a tape to firmly attach the film to the receiving paper tube. How to clean and maintain the sealing machine Regularly clean the surface of the machine, the bottom plate and the lower die slide, the groove, the upper die inner plate and the positioning rod (Note: the power must be turned off and return to normal temperature). The lower die slide, the pressure bar bearing, the eccentric wheel and the guide post, the guide rail and other transmission parts Add butter regularly, How to use the sealing machine correctly 1. It is not suitable for metal containers and metal covers, and it is not allowed to press the start button on the metal table, otherwise the machine will be damaged.
Step 2, sealing operation steps (panel operation instructions)
Turn on the power, turn on the power switch, the indicator light is on, set the temperature controller to the predetermined temperature, and the green heating indicator lights up. When the upper hot plate reaches the predetermined temperature, the red constant temperature indicator lights up (the electric heating device alternates between heating and holding state when the sealing machine is working, so the green and red indicator lights are alternately displayed, which is normal). Put the plastic cup into the lower mold slide and push the lower mold slide to the determined position by hand (if it is a fully automatic sealing machine or automatic sealing machine, after placing the plastic cup, the lower mold slide will automatically enter), press down Seal the handle of the machine to the maximum stroke, hold it for 1~2 seconds, then slowly raise the handle and push it to the original position. Pull out the lower mold slide and take out the plastic cup.
Put in the final sealing cup for another cycle.
To ensure the performance of the machine. To clean the cutter: first use the cotton ball to plug the two drain holes of the lower mold, pour the boiling water into the groove of the lower mold, fill it up, then push the lower mold slide into place, press the upper mold down, press To the lowest point,
Allow the knife to soak for a few minutes until it is clean and repeat several times.
2. Insert the induction air plug and tighten the screw before turning on the power.
3. Use single-phase three-wire power cord. For operator safety, be sure to use single-phase three-wire power socket. The work floor must be dry to keep insulation.
4, with temperature overheating automatic protection function, when the internal temperature of the machine is overheated, the buzzer sounds in the machine " abnormal protection (PRO. MD.)" yellow indicator light, at this time should turn off the main power switch, standby cooling After the buzzer stops,
Continue working.
5. During the working process, always touch the surface of the sensor head to check whether it is overheated. If it is found that the hot hand should stop heating, it should work after cooling (cooling can not turn off the power), when the “WARM UP†green indicator light is off, Do not press the start button to avoid false triggering. Local work 
Related accessories: Disc type automatic drop cup filling and sealing machine.doc