Filling and Sealing Machines Before using the machine, some basic checks should be performed on the machine to ensure that the machine is not malfunctioning. Generally can do the following:

1. The machine adopts 220V single-phase AC power supply and is equipped with a three-pin socket for grounding. Before use, check whether the voltage of the power supply meets the requirements, whether the wiring is secure and the ground wire is connected;

2. Adjust the height of the filling and sealing machine as needed;

3. Check whether the lubrication of each rotating part is good and inject a proper amount of lubricating oil;

4. If the initial use or use interval is too long, the electric heating tube may be damp and the insulation resistance is reduced (normal), and the low temperature preheating should be carried out for half an hour before normal operation;

5. Adjust the height and front and rear position of the conveyor table according to the size and filling amount of the bag. Height adjustment should use the special special meniscus wrench to loosen the bridge gear nut, and adjust it properly after tightening: According to the seal size, you need to adjust the position of the seal width positioning frame.

The above is the boot precautions, then what should be done when the machine finishes the sealing work and needs to stop the operation to keep the machine from being worn out, keep it in a normal state, as long as it is done at two points, that is
1. In order to extend the service life of the sealing belt, before stopping the machine, the heating switch must be disconnected (the indicator light in the button is off), the temperature of the ironing head is lowered, and the sealing belt is continuously operated for a period of time;

2. After about half an hour, the fan switch and power switch can be disconnected, and the whole machine stops. At this time, the indicator light in the button is off.

Moreover, when we use the filling and sealing machine, we should ensure the correct operation, only the correct and reasonable use, so that the equipment can be operated normally, and the production efficiency of the equipment can be guaranteed to maximize the benefits of the production enterprise. Create more benefits. Moreover, in the process of using the sealing machine, we should pay great attention to the maintenance and maintenance of the equipment. Only in this way can the equipment exert its maximum value.