As we all know, equipment of the best quality, as long as it does not operate in the correct way, does not clean and maintain it, then it is difficult to have a long life and good working effect, so is the sealing machine, if the operation is not correct, then there will be very It may cause damage to the causality. In order to make everyone know about the cleaning and maintenance of the sealing machine, and make their own sealing machine work better, let's briefly introduce it to everyone, when cleaning and maintenance of the equipment. Should pay attention to, I hope to have some help for everyone.

In fact, the products that need to be sealed have certain shortcomings, such as fragile, inconvenient to transport, or easy to tide. Therefore, when it comes into contact with water vapor in the air, it is easy to deteriorate, or it is easy to be contaminated. In short, the product itself exists. Certain shortcomings make us need to seal it in order to reduce the losses caused by these shortcomings. Therefore, the timing cleaning of the sealing machine is necessary, because on the one hand, it can ensure the normal operation of the equipment, and secondly, it is guaranteed. The product will not be polluted during the sealing process. Therefore, the surface of the machine and the bottom plate of the sealing machine, as well as the lower die slide, the groove, the upper mold inner plate and the positioning rod should be cleaned regularly. The process must be remembered, When cleaning, make sure that the power is off and at room temperature.

In addition to the above mentioned cleaning, for the lower die slide, pressure bar bearing, eccentric wheel, guide column, guide rail and other transmission parts of the sealing machine, it is necessary to add butter in time to ensure the performance of the sealing machine. The important method of cleaning the tooth cutter is more particular. First, use the cotton ball to plug the two drain holes of the lower mold, pour the boiling water into the groove of the lower mold until it is full, and then push the lower mold slide into place. Press the upper mold down, press it to the lowest point, let the tooth cutter soak for several minutes until it is cleaned, and repeat it several times. Of course, there are some things to be aware of the cleaning and maintenance of the sealing machine, but the above is for the protection of the sealing machine. is the most important.