To purchase slaughtering equipment, we must first look at the principle of the slaughtering equipment, such as a set of poultry slaughtering equipment, which is mainly from the scalding pool, hair removal machine (with vertical hair removal machine and horizontal hair removal machine, according to its own factory) The layout is implemented by choice), and the spiral is composed of a cold machine. I hope that Chavez Xiaobian will help you with the little knowledge! Â Â In Vitro Diagnostics,Urine Ketone Strips,Ketone Urine Test Strips,Home Test Ketone Test Strips Changchun Medicon Technology Development Co., Ltd , http://www.teststrip.pl
The immersion pool is mainly used to make the water outside the scalding pool flow through the blower, and the birds are heated. The motor drives the propeller to pump the water outside the scalding pool and scouring it. Therefore, the local curvature of the hot pool is not too small or too small. Will affect the temperature of the heating of the birds, the same is not easy to be too large, the general should be between 140-150 degrees. Some manufacturers of the lower part of the propeller are welded into a cone type, and some manufacturers are welded to form a body. Regardless of the shape, the spacing should not be greater than 4 cm.
The slope of the T- shaped steel at the front end of the pool *** must be steep. Otherwise, the chain from the upper part will have a certain impact on the front end of the hot pool. If it is long, it will affect the life of the sprocket.
From the hot pool, the next step is to enter the hair removal machine. Whether it is a vertical hair removal machine or a horizontal hair removal machine, the motor is used to drive the glue stick to perform a continuous alternating blow to the birds, and the hair is knocked off. Go out from the discharge port, so you must pay attention to the quality of the glue stick when purchasing the hair removal machine. The soft and hard must be moderate. If you look at the appearance, you can see if the glue stick can be the same, can you have the glue? The spacing between the rod and the glue stick is too small. It should also be noted that waterproofing equipment must be added to the outside of the hair removal machine to prevent the water from spilling out and affect the life of the rolling shaft bearing.
Then the spiral meets the cold machine. It is important to realize the coldness of the poultry at the front end of the process, and to deacidify together. When the rotor of the pre-cooler rotates, the friction of the pre-cooler body shall not occur, and the rotor may not be partially deformed. It is necessary to carry out double-sided welding as part of the load-bearing part. That's it. Of course, there are still a lot of details. If you find any doubts at the purchase site, you must ask why.